Projects:Delta printer: verschil tussen versies
Naar navigatie springen
Naar zoeken springen
Geen bewerkingssamenvatting |
Geen bewerkingssamenvatting |
||
Regel 1: | Regel 1: | ||
We got donated a FLSUN Delta Kossel. It has a mks base v1.5 board. | We got donated a FLSUN Delta Kossel. It has a mks base v1.5 board. | ||
Link list | =Hardware= | ||
Stepper motors: SL42STH40-1684A | |||
Controller: mks base v1.5 board | |||
Power supply: S-200-12 with 12V 16.7A output | |||
=Software= | |||
Using [https://www.pronterface.com/ proterface], we discovered the original firmware: | |||
{| | |||
|- | |||
! scope="col" |COLUMN1 | |||
|- | |||
|ROW1 | |||
|- | |||
|ROW2 | |||
|} | |||
== Link list == | |||
https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit | https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit |
Versie van 13 okt 2024 13:58
We got donated a FLSUN Delta Kossel. It has a mks base v1.5 board.
Hardware
Stepper motors: SL42STH40-1684A Controller: mks base v1.5 board Power supply: S-200-12 with 12V 16.7A output
Software
Using proterface, we discovered the original firmware:
COLUMN1 |
---|
ROW1 |
ROW2 |
Link list
https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit
https://www.youtube.com/watch?v=lOb5BuwkcNI
Todo:
- Install the firmware using the following tutorial (interesting bit starts at 5:00 mark), calculator is at https://rev22.github.io/RepRapCalculator/#MotorStuffSPMB
- Setup calibration using the auto calibration feature: https://marlinfw.org/docs/gcode/G033.html
- profit!?