Projects:Delta printer: verschil tussen versies
Geen bewerkingssamenvatting |
|||
Regel 3: | Regel 3: | ||
=Hardware= | =Hardware= | ||
Stepper motors: SL42STH40-1684A | * Stepper motors: SL42STH40-1684A | ||
Controller: mks base v1.5 board | * Controller: mks base v1.5 board | ||
Power supply: S-200-12 with 12V 16.7A output | * Power supply: S-200-12 with 12V 16.7A output | ||
=Software= | =Software= | ||
Regel 58: | Regel 58: | ||
== Link list == | == Link list == | ||
https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit | * https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit | ||
* https://www.youtube.com/watch?v=lOb5BuwkcNI | |||
https://www.youtube.com/watch?v=lOb5BuwkcNI | |||
=== Todo: === | === Todo: === |
Versie van 13 okt 2024 14:03
We got donated a FLSUN Delta Kossel. It has a mks base v1.5 board.
Hardware
- Stepper motors: SL42STH40-1684A
- Controller: mks base v1.5 board
- Power supply: S-200-12 with 12V 16.7A output
Software
Using proterface, we discovered the original firmware:
Old software |
---|
echo:Marlin1.0.0
echo: Last Updated: Sep 20 2016 17:01:22 | Author: (Kossel KOSSEL) Compiled: Sep 20 2016 echo: Free Memory: 3738 PlannerBufferBytes: 1232 echo:Hardcoded Default Settings Loaded echo:Steps per unit: echo: M92 X100.00 Y100.00 Z100.00 E150.00 echo:Maximum feedrates (mm/s): echo: M203 X200.00 Y200.00 Z200.00 E200.00 echo:Maximum Acceleration (mm/s2): echo: M201 X3000 Y3000 Z3000 E3000 echo:Acceleration: S=acceleration, T=retract acceleration echo: M204 S3000.00 T3000.00 echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s) echo: M205 S0.00 T0.00 B20000 X20.00 Z20.00 E20.00 echo:Home offset (mm): echo: M206 X0.00 Y0.00 Z0.00 echo:Endstop adjustement (mm): echo: M666 X0.00 Y0.00 Z0.00 echo:PID settings: echo: M301 P22.20 I1.08 D114.00 |
Link list
- https://www.3dprintersbay.com/flsun-autolevelling-kossel-diy-kit
- https://www.youtube.com/watch?v=lOb5BuwkcNI
Todo:
- Install the firmware using the following tutorial (interesting bit starts at 5:00 mark), calculator is at https://rev22.github.io/RepRapCalculator/#MotorStuffSPMB
- Setup calibration using the auto calibration feature: https://marlinfw.org/docs/gcode/G033.html
- profit!?