Tool:Ultimaker 2 (3D printer)
We have an Ultimaker 2 3D printer at the space.
It has an octoprint connected to it, login can be requested.
Some settings that are needed in cura to make a good print:
It is an ultimaker 2, but after setting is to ultimaker 2, change these settings to print via octoprint:
G-code flavor "Marlin"
G21 ;metric values G90 ;absolute positioning M82 ;set extruder to absolute mode M107 ;start with the fan off G28 Z0 ;move Z to bottom endstops G28 X0 Y0 ;move X/Y to endstops G1 X15 Y0 F4000 ;move X/Y to front of printer G1 Z15.0 F9000 ;move the platform to 15mm G92 E0 ;zero the extruded length G1 F200 E10 ;extrude 10 mm of feed stock G92 E0 ;zero the extruded length again G1 Y50 F9000 ;Put printing message on LCD screen M117 Printing...
M104 S0 ;extruder heater off M140 S0 ;heated bed heater off (if you have it) G91 ;relative positioning G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure G1 Z+0.5 E-5 X-20 Y-20 F9000 ;move Z up a bit and retract filament even more G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way M84 ;steppers off G90 ;absolute positioning ;Version _2.6 of the firmware can abort the print too early if the file ends ;too soon. However if the file hasn't ended yet because there are comments at ;the end of the file, it won't abort yet. Therefore we have to put at least 512 ;bytes at the end of the g-code so that the file is not yet finished by the ;time that the motion planner gets flushed. With firmware version _3.3 this ;should be fixed, so this comment wouldn't be necessary any more. Now we have ;to pad this text to make precisely 512 bytes.